HC-SR501 Adjust IR Pyroelectric Infrared PIR Motion Sensor Detector ModuleIt is great for microcontrollers such as arduino or funduino and many more including the rasberry pi! It is a HC--SR501
Sensor Module With an operating voltage of 5v to 20v
Operating voltage. It has a high value of 3.3 volts and a low of 0 (it is either on or off). It's delay time can be adjusted from 5 to 200seconds as well as the sensing range from 3meter to 7meters.
The entire sensor with the board is 32mm by 24mm (standard pir motion sensor).
The sensor either gives off a 3.3volt high value when motion is detected and then resumes or continues to give off a 0 voltage when no motion is detected. If you use an arduino or other micro controllers you can use the 3.3 volt out to power the sensor or use the 5volt power pin (vcc) to power the sensor. Either one will work. Working voltage range: DC 4.5-20V Static current: <50uA High level output: 3.3 V / low 0V
Trigger mode: L unrepeatable trigger /H repeated trigger (Default Repeating trigger)
Delay time: 0.5-200S (adjustable) can be produced range 0.1 seconds - a few minutes
Blocking time: 2.5S (the default) can be produced range 0.1 seconds, tens of seconds Size: 32mm*25mm circuit board Induction angle: <100 degree cone angle Working temperature: -15-+70 degrees Induction of lens size: diameter: 23mm (default)
Package Include: 1 x HC-SR501 Module
Review / Comment
Air Plane Shipping to your destination ( 9-27 ) days.